topic Re: Debugging of a subroutine pool. in Application Development and Automation Discussions

Debugging of a subroutine pool.

Former Member — Thu, 09 Feb 2006 21:35:10 GMT

Hi there,

Does anyone knows if is posible to debug a subroutine pool?

I'm trying to print a smartform of a RFQ using the function ME_READ_PO_FOR_PRINTING, but the program prints a different requisition a not the one selected.

I want to capture the RFQ number and pass it as a parameter to the smartform but for any reason I can't get the correct number.

I put a break-point on the program but it doesn't work and I am unable to track and find the problem.

Any help will be appreciated.

Thanks,

Orlando

Re: Debugging of a subroutine pool.

Former Member — Thu, 09 Feb 2006 21:43:24 GMT

Hi Orlando,

Are you printing the RFQ from ME52N by assigning an O/P ?

If so then assign O/P to your RFQ and then set further data dispatch time as send as Period job.

Then use program RSNAST00 and you can debug .

If you are doing as a back ground job then :

type JDBG in the OK-code and press enter

Hope this may help you.

Lanka

Message was edited by: Lanka Murthy

Re: Debugging of a subroutine pool.

RichHeilman — Thu, 09 Feb 2006 21:44:25 GMT

Sounds like that subroutine is being fired in another process. If you can, start the debuggin during your dialog process, once inside the debugger, switch on the Update Debugging, by clicking "Settings" --> UPdate Debugging. Now hit F8 to get to your other breakpoint. Hopefully it will stop there.

Regards,

Rich Heilman

Re: Debugging of a subroutine pool.

former_member186741 — Fri, 10 Feb 2006 01:30:46 GMT

if Rich's suggestion doesn't work try "Settings" --> System Debugging instead.