topic Re: ale/idoc setting in Application Development and Automation Discussions

ale/idoc setting

Former Member — Mon, 23 Mar 2009 10:18:55 GMT

Please use more informative subjects in future. How are we supposed to differentiate between your questions when you keep using the same subject?

i created a distribution model and when i am distributing it i am getting the following message

"RFC destination for synchronous communication (message type SYNCH

Partner profile LS 800 SYNCH does not exist

Generate partner profile

or specify outbound partner profiles for message type SYNCH"

what should i do ...i maintained synch message type in outbound parameteres of partner profile..

can someone tell me what i need to do?

Edited by: Matt on Mar 23, 2009 2:14 PM

Re: ale/idoc setting

Former Member — Mon, 23 Mar 2009 10:22:43 GMT

hi,

Check for the following.

Was the RFC destination maintained through TCODE SM59.

Were the logical systems created and assigned. ??

And also check for the inbound settings too.

Regards

Sharath

Re: ale/idoc setting

Former Member — Mon, 23 Mar 2009 10:25:26 GMT

Hi,

First of all generate the partner profile in BD64 by following path.

Environment ->Generate Partner Profiles.

Thanks,

Asit Purbey.

Edited by: Asit Purbey on Mar 23, 2009 11:25 AM

Re: ale/idoc setting

Former Member — Mon, 23 Mar 2009 10:39:07 GMT

when i am generating partner profile the following mesage is displayed...

"No messages have been defined for the selection conditions in the model"

Re: ale/idoc setting

Former Member — Mon, 23 Mar 2009 11:16:04 GMT

Hi,

Check your Outbound and inbound patner profile are set up correctly or not. Check in distribution model Sender system, receiver system and message type has been maintained correctly.

Thanks,

Asit Purbey.

Edited by: Asit Purbey on Mar 23, 2009 12:20 PM

Re: ale/idoc setting

Former Member — Mon, 23 Mar 2009 12:06:07 GMT

hi,

Check all the steps one bye one . Are u can Add message type SYNCH in sending as outbound and in Recieving as inbound .

let me know if any queries.

~linganna

Re: ale/idoc setting

Former Member — Mon, 23 Mar 2009 12:18:00 GMT

Hi,

Either configure all partner profiles in WE20 and then the distribution model in BD64 and distribute the model view or, set up the distribution model with the required message types along with SYNCH message type and generate partner profiles from BD64.

~ Bineah.

Re: ale/idoc setting

matt — Mon, 23 Mar 2009 13:14:13 GMT

Please use more informative subjects in future. How are we supposed to differentiate between your questions when you keep using the same subject?

Re: ale/idoc setting

Former Member — Wed, 25 Mar 2009 09:41:11 GMT

thanks alot