topic Re: FUNCTION 'F4IF_INT_TABLE_VALUE_REQUEST' in Application Development and Automation Discussions

FUNCTION 'F4IF_INT_TABLE_VALUE_REQUEST'

Former Member — Fri, 21 Nov 2008 05:25:05 GMT

HI,

I am writing the value request help for a field which is in the selection screen using the Function 'F4IF_INT_TABLE_VALUE_REQUEST'.

I am able to populate the Values in the help screen.

The problem is that the number of output values is limited to 5000 whereas the total number of entries is >5000.

Thus the entries beyond 5000 are not shown.

How do I fetch the entries beyond 5000 ?

Some change in the program can be done or is there another function module to be used.

Regards,

Amit

Re: FUNCTION 'F4IF_INT_TABLE_VALUE_REQUEST'

Former Member — Fri, 21 Nov 2008 05:26:23 GMT

The maximum you can see is 5000 I suppose, beyond 5000 entries I dont think it is possible.

Regards,

Vishwa.

Re: FUNCTION 'F4IF_INT_TABLE_VALUE_REQUEST'

Former Member — Fri, 21 Nov 2008 05:38:06 GMT

please Check the following Code

TABLES : MARD.

DATA: BEGIN OF IT_MARD OCCURS 0,

WERKS LIKE MARD-WERKS,

END OF IT_MARD.

DATA : T_RETURN TYPE STANDARD TABLE OF DDSHRETVAL WITH HEADER LINE.

parameters : P_WERKS LIKE MARD-WERKS.

AT SELECTION-SCREEN ON VALUE-REQUEST FOR P_WERKS.

SELECT WERKS FROM MARD UP TO 10 ROWS INTO table IT_MARD.

CALL FUNCTION 'F4IF_INT_TABLE_VALUE_REQUEST'

EXPORTING

RETFIELD = 'WERKS'

DYNPPROG = SY-REPID

DYNPNR = '1000'

DYNPROFIELD = 'P_WERKS'

VALUE_ORG = 'S'

TABLES

VALUE_TAB = IT_MARD

RETURN_TAB = T_RETURN

EXCEPTIONS

PARAMETER_ERROR = 1

NO_VALUES_FOUND = 2

OTHERS = 3.

hope this helps

regards

Aakash Banga

Re: FUNCTION 'F4IF_INT_TABLE_VALUE_REQUEST'

Former Member — Fri, 21 Nov 2008 05:41:42 GMT

Hi Amit,

Please check the number of hits after you get the pop up of F4 help, i think it is set to 5000 hits only.

just remove the 5000 and leave it blank.

or take the help of basis people.

regards

Ramchander Rao.K