topic Re: Message Class in Application Development and Automation Discussions

Message Class

Former Member — Wed, 05 Nov 2008 09:36:20 GMT

I am using a dynamic table for displaying the output in ALV list.If there is no data then I am using a standard message class to display error message ' No output'.

The logic is,

IF <gi_dynitab> IS INITIAL.

MESSAGE s007 .

ENDIF.

but when there is no data it is not displaying this message.

Is the logic correct? is there any other way to display it?

Or I have to again change the settings ? if yes, how?

Re: Message Class

Former Member — Wed, 05 Nov 2008 09:37:55 GMT

hi,

I think you write

raise message ....

regards,

Lokesh

Re: Message Class

Former Member — Wed, 05 Nov 2008 09:43:10 GMT

This logic was working for me previously.

IF <gi_dynitab> IS INITIAL.

MESSAGE s007 .

ENDIF.

Edited by: Reshma Vaidya on Nov 5, 2008 10:43 AM

Re: Message Class

Former Member — Wed, 05 Nov 2008 09:45:25 GMT

Hi,

Its right. Try to debug and find the reason.

u can use like this also.

MESSAGE ID 'AB' TYPE 'S' NUMBER '050'.

Also check whether that message class and message exists or not.

Rhea.

Re: Message Class

Former Member — Wed, 05 Nov 2008 09:47:50 GMT

You should be using MESSAGE e007 instead of MESSAGE s007, to raise an error message and stop the processing. A success message is ignored at runtime, and the processing just continues.