topic Workflow Upgrade error - program not unicode compatible in Application Development and Automation Discussions

Workflow Upgrade error - program not unicode compatible

Former Member — Mon, 03 Nov 2008 20:01:20 GMT

After our upgrade to ECC 6.0 the workflow generated programs are receiving the same error that the "program is not unicode compatible according to the program attributes". This is also captured via uccheck. Where do you set this flag for the workflow generated program via transaction SWO1?? I cannot find this attribute? You cannot edit the attributes via se38 and when I tried to set this attribute using se80, the error still happens.

Re: Workflow Upgrade error - program not unicode compatible

b_deterd2 — Mon, 03 Nov 2008 21:03:29 GMT

Hi,

run program (SE38) SWO_SET_UC_FLAG.

regards,

Bert

Re: Workflow Upgrade error - program not unicode compatible

Former Member — Mon, 03 Nov 2008 22:01:37 GMT

if it shows in UCCHECK, you can check the box..i.e select that program and simply press the Butoon "Set Unicode Attribute" on the toolbar.

This shall take care.

Thanks

Kiran