topic Re: Modifying Standard Screen in Application Development and Automation Discussions

Modifying Standard Screen

Former Member — Tue, 11 Nov 2008 12:58:16 GMT

Hello all,

I have copied the standard screen to the Zscreen and added 4 new fields.

The fields are added successfully.

However I am facing one problem.

The fields are available in editable mode always.

Even if I go to display mode, they are still editable. The other existing fields however goes into display mode.

Anyone have any idea about how to go about this?

Help would be appretiated.

Regards,

~Pranu

Re: Modifying Standard Screen

Former Member — Tue, 11 Nov 2008 13:00:44 GMT

Hello,

You need to modify the screen according to the action that your are performing (ok_code).

case ok_code.

when 'DISP'.

Loop at screen.

screen-output = 0.

modify screen.

endloop.

when 'CRT'.

****

endcase.

Thanks,

Jayant

Re: Modifying Standard Screen

Former Member — Tue, 11 Nov 2008 13:04:37 GMT

Go to the screen flow logic and in the PBO write a logic...

PBO

if sy-pfkey eq 'DIS'. -

> GUI status

loop at screen.

check screen-group2 = 'TST'. ---> ur group of fields

screen-input = '0'.

modify screen.

endloop.

endif.

Re: Modifying Standard Screen

Former Member — Tue, 11 Nov 2008 13:05:02 GMT

My fields are added in the subscreen.

The subscreen is going into display mode so I assume even my custom fields should go.

Pelase correct me if I am wrong.

And if I have to add the code you have said, where do I actually put it?

Thanks again

Re: Modifying Standard Screen

former_member201364 — Fri, 14 Nov 2008 09:03:36 GMT

Hi Pranu,

You have to add the above logic for the 4 extra fields in the PBO of the ZScreen u have created.

Regards

Poornima

Re: Modifying Standard Screen

Former Member — Fri, 14 Nov 2008 09:08:25 GMT

Hi,

Loop at screen.

screen-output = 0.

modify screen.

endloop.

Tks,

Krishna..