topic Re: Check statement. in Application Development and Automation Discussions

Check statement.

Former Member — Wed, 12 Nov 2008 13:30:08 GMT

Hi,

I am using the following stat for checking whether the the TCODE is in the given range in tab lt_tab3.

If i give values in in LOW & HIGH and In HIGH the following stat working fine. But If i give the value in Only Low field Bothe stat r not working.

CHECK lt_tab3-tcode between lt_tab1-low and lt_tab1-high.

OR (I'm using only one stat from these)

IF LT_TAB3-TCODE GE LT_TAB1-LOW LT_TAB3-TCODE LE

LT_TAB1-HIGH.

Give me suggestions

Re: Check statement.

Former Member — Wed, 12 Nov 2008 13:34:21 GMT

Hi,

I'm assuming the lt_tab1 is a range or select-option. If that is the case. Just use the statment for checking if the valud in within the list of specified value range, as follows :

check lt_tab3-tcode in lt_tab1 .

if lt_tab3-tcode in lt_tab1 .

endif.

regards,

Advait

Re: Check statement.

MarcinPciak — Wed, 12 Nov 2008 13:35:36 GMT

You must use this instead


check lt_tab3-tcode in lt_tab1.

It will solve both cases.

Re: Check statement.

Former Member — Wed, 12 Nov 2008 13:40:08 GMT

Hi,

I think you can do some changes to the internal table first.

if the lt_tab1-high is initial.

lt_tab1-high = lt_tab3-tcode.

endif.

Then you can use one of the following statement:

CHECK lt_tab3-tcode between lt_tab1-low and lt_tab1-high.

OR (I'm using only one stat from these)

IF LT_TAB3-TCODE GE LT_TAB1-LOW LT_TAB3-TCODE LE

LT_TAB1-HIGH.

Hope this will help you.

Re: Check statement.

Former Member — Wed, 12 Nov 2008 15:10:03 GMT

Hi Advait

Thnx, ur answer helped me.