topic Re: IF condition in Script in Application Development and Automation Discussions

IF condition in Script

Former Member — Thu, 16 Mar 2017 10:05:48 GMT

Hi,

Need help on if condition in script.

If condition not working in script

/: if &VAR& NE '0.00'.

/:fill.

/:else.

/:fill.

/:endif.

Re: IF condition in Script

Jelena_Perfiljeva — Thu, 16 Mar 2017 21:47:20 GMT

Not sure what answers are you expecting with so little information provided... What have you tried so far to troubleshoot this? Care to post any factual evidence, like a debugger screenshot showing the value of &VAR& or whatever "fill" is?

Re: IF condition in Script

Former Member — Fri, 17 Mar 2017 07:57:19 GMT

Fullstops.

Sapscript commands are not terminated with full stops.

Re: IF condition in Script

Jelena_Perfiljeva — Fri, 17 Mar 2017 17:55:34 GMT

I'm assuming you meant dots. This is correct but I believe it works either way. Just checked in one of our SAPScripts and it has commands with and without a dot at the end. Although maybe it actually does not work and we just don't know. 🙂

Still would be nice of OP to add more info.

Re: IF condition in Script

Former Member — Mon, 20 Mar 2017 08:09:26 GMT

I worked on a project and it was obvious they had only tested the default scenario because every sapscript command was terminated with a dot, fullstop, period or whatever you'd like to call it. We made our changes which didn't work because they were in the middle of all this and we then had put right the existing stuff....

I would check the 'we just don't know' scenario.... 😉