topic Re: Report Output in Application Development and Automation Discussions

Report Output

Former Member — Tue, 23 Sep 2008 16:40:47 GMT

Hi,

i am Executing a report, i got the output (after providing the required info in the selection screen) ,when i press back button,it will move over to the selection screen, from there when i change the variant and execute the report i cant see the current output instead i am seeing the previous output . what could be the possible problem?

Regards,

Vijaya

Re: Report Output

Former Member — Tue, 23 Sep 2008 16:55:08 GMT

Hi,

I think your problem is with the refreshing of the old variant values.

When you click the back button you make sure that you are clearing the selection screen elements and then when you select the new variant, you press enter and execute the report.

I guess this would solve your problem.

Regards,

Kiran

Re: Report Output

Former Member — Tue, 23 Sep 2008 17:11:10 GMT

Dear Kiran,

when i press BACK button and change the variant and press ENTER still it was doing the same,and how to clear up the previous variants immediately when i press BACK.

Regards,

Vijaya

Re: Report Output

Former Member — Tue, 23 Sep 2008 17:57:26 GMT

Hi,

Try with At Selection-Screen Output. Here you can clear all the fields.

At selection-screen output.

clear <fields>.

Regards,

Bhaskar

Re: Report Output

Former Member — Tue, 23 Sep 2008 20:35:12 GMT

Hi,

Kiran I have Cleared the selection screen elements also still the same problem.

what could be the reason kiran.

Regards,

Vijaya

Re: Report Output

Former Member — Tue, 23 Sep 2008 20:44:09 GMT

in ur program after displaying the report refresh ur final output table.

After this change test ur code and check whether it is still displaying the old output or not.

Re: Report Output

Former Member — Tue, 23 Sep 2008 21:29:36 GMT

If you are using an internal output table with a header line, then do a CLEAR and a REFRESH of your output table before you select your data.

Also, how are you selecting your data?

If you are not clearing your output table and you are using SELECT .. FROM .. APPENDING output table. Then you will also have the problem. In this case just use an "INTO TABLE" instead.

SELECT result

FROM source

INTO|APPENDING target

[[FOR ALL ENTRIES IN itab] WHERE sql_cond]

[GROUP BY group] [HAVING group_cond]

[ORDER BY sort_key].

Hope This Helps

Jayden

Re: Report Output

Former Member — Tue, 23 Sep 2008 21:52:28 GMT

you can also initialize in initialize event.

thanq