topic Re: AT EXIT-COMMAND doesn't work in Application Development and Automation Discussions

AT EXIT-COMMAND doesn't work

Former Member — Thu, 28 Aug 2008 13:24:51 GMT

Hi experts,

In screen painter I use AT EXIT-COMMAND to exit current screen as the following code. But it doesn't exit the screen if ok_code = 'create' while other ok_code work well. Can anyone tell me that's why?

Thanks!


module exit.
  if SY-UCOMM = 'EXIT' or SY-UCOMM = 'BACK'.
    LEAVE PROGRAM.
  elseif SY-UCOMM = 'CLEAR' or SY-UCOMM = 'CREATE'.
    CALL SCREEN 100.
endmodule.

Re: AT EXIT-COMMAND doesn't work

JozsefSzikszai — Thu, 28 Aug 2008 13:27:05 GMT

probably the create command is not defined as exit command?

Re: AT EXIT-COMMAND doesn't work

Former Member — Thu, 28 Aug 2008 13:28:12 GMT

write this statement in PAI

and check weather sy-ucomm capturing the key r not

MODULE EXIT.

IF sy-ucomm = 'LEAV'

SET SCREEN 0.

LEAVE SCREEN.

ENDIF.

ENDMODULE.

Regards

Anbu B

Re: AT EXIT-COMMAND doesn't work

Former Member — Thu, 28 Aug 2008 13:28:34 GMT

Did you Set the Function code as Type E then only it will tigger.

check this program,,.

DEMO_DYNPRO_AT_EXIT_COMMAND

Re: AT EXIT-COMMAND doesn't work

Former Member — Thu, 28 Aug 2008 13:34:48 GMT

Hi,

module exit.

if SY-UCOMM = 'EXIT' or SY-UCOMM = 'BACK'.

LEAVE LIST-PROSSESING." TO COME BACK

elseif SY-UCOMM = 'CLEAR' or SY-UCOMM = 'CREATE'.

REFRESH ITAB." FOR INTRNAL TABLE

CLEAR WA." FOR WORKAREA

CALL SCREEN 100.

endmodule.

NOW USE THIS .

Thanks & Regards,

D Tarun Kumar.

Re: AT EXIT-COMMAND doesn't work

Former Member — Thu, 28 Aug 2008 13:59:39 GMT

Thanks for all you. You remind me...