topic Re: Problems with SELECT when executing program via R3TR XPRA in Application Development and Automation Discussions

Problems with SELECT when executing program via R3TR XPRA

Former Member — Tue, 02 Sep 2008 08:25:53 GMT

Hi,

I execute a report via importing a TP transport into a SAP system. The transport contains the entry R3TR XPRA programname. The program will be executed but a SELECT statement for selecting the entries of DB table SE16N_LT fails, although there are entries within this table.

If I execute the program directly via SE38 (F8) then the SELECT statements works fine. Are there any special table settings (Data Dictionary, SE11) which will lead to these two different results?

Any helpful information will be appreciated.

Thanks,

Uwe

Re: Problems with SELECT when executing program via R3TR XPRA

Former Member — Tue, 02 Sep 2008 08:35:54 GMT

This should not occur...check if this table SE16_LT is client dependent...n that you are executing the report in the same client

~Piyush Patil

Re: Problems with SELECT when executing program via R3TR XPRA

Former Member — Tue, 02 Sep 2008 08:45:44 GMT

Hi,

The report will be executed in the same client.

Uwe