topic Re: exit screen doesn't work in Application Development and Automation Discussions

exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:30:39 GMT

Hi everyone,

In screen painter there is the code:

WHEN 'EXIT'.

LEAVE PROGRAM.

But it doesn't exit the current screen. What's the problem? (leave screen doesn't work either.)

Thanks!

Re: exit screen doesn't work

GauthamV — Fri, 22 Aug 2008 09:32:52 GMT

hi,

use this.

WHEN 'EXIT'.

leave to screen 0.

but if u have any manditory fields in screen then u have to use at-exit command module.

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:33:14 GMT

Hi,

Use At Exit-Command.

Regrads

Guru

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:33:30 GMT

check the OK_CODE in Element List tab in SE51.

regards

deva

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:33:44 GMT

Hi,

Make sure whether the function code and ok code is assigned or not. If yes then it should work properly.

Regards,

Sathish Reddy.

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:36:47 GMT

Hi,

In your PAI add a module as follows

MODULE EXIT_XXXX AT EXIT-COMMAND.

MODULE EXIT_XXXX.

if ok_code = 'EXIT'.

LEAVE PROGRAM.

ENDIF.

ENDMODULE.

EXIT button on the toolbar has FUNCTION TYPE 'E' only function type's can enter a module with addition AT EXIT-COMMAND.

Regards,

Raj.

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:41:31 GMT

First check in Debug mode what is the ok_code value, is it EXIT or is it different from EXIT check it.,

WHEN 'EXIT'.

LEAVE PROGRAM.

I feel you mentioned the different Ok code.

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:53:41 GMT

Thanks all of you. In fact I defined a field as required so when I exit there is a error message 'must input the required field'. So how to solve that?

Otherwise don't know much about AT EXIT-COMMAND module and I tried it but it doesn't work...

Thanks!

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 09:55:20 GMT

Check this Program

DEMO_DYNPRO_AT_EXIT_COMMAND

Re: exit screen doesn't work

GauthamV — Fri, 22 Aug 2008 10:01:49 GMT

Hi,

use this.

Process After Input.

Module exit AT EXIT-COMMAND.

in program.

Case Okcode.

When 'Exit'.

leave to screen 0.

Automatic field checks can be avoided by AT EXIT-COMMAND, Which works exactly the same way as cancel works on application tols bar.

EXIT button on the toolbar has FUNCTION TYPE 'E' only function type's can enter a module with addition AT EXIT-COMMAND

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 10:16:01 GMT

hi,

i think you have written wrong FCT code.

your FCT code should be 'EXIT' in caps.

check it.

hope it may help you.

thanks,

Sachin

Re: exit screen doesn't work

Former Member — Fri, 22 Aug 2008 11:51:48 GMT

Thanks Gautham. I use your code in the programme but it says '. expected after exit' when active. Seems I can't add the module exit AT-EXIT COMMAND. What's wrong?

Thanks.