topic Re: program was temporarily buffered.. in Application Development and Automation Discussions

program was temporarily buffered..

Former Member — Fri, 01 Aug 2008 12:53:29 GMT

hi,

i am in se80 and often getting error that says

the program ZXXX was temporarily buffered

(possibly due to system error/failure)

choose one of the options..

1. get temp version

2.get from database but keep temp version

blah blah..

why ??

thks

Re: program was temporarily buffered..

Former Member — Fri, 01 Aug 2008 12:56:58 GMT

Hello,

If you are editing program and try to run without saving program, SAP abap processor try to save the version temporary and run the active version of program.

Make sure that you run save and activate program before you test it.

Regards,

Mahesh

Re: program was temporarily buffered..

ThomasZloch — Fri, 01 Aug 2008 12:57:17 GMT

maybe you logged off without saving the program.

check out whether "temp version" or "database version" is your latest one, then once you saved the program correctly, you can delete the "temp version", should you be asked again.

Thomas

Re: program was temporarily buffered..

Former Member — Fri, 01 Aug 2008 13:20:27 GMT

Hi There.

I would like to suggest,

The Cause is simple, You did not activate your program/report before executing.

The Solution is also simple, Kindly activate your program/report before executing to avoid any chances.

Always follow a standard convention,

SYNTAX CHECK, SAVE & ACTIVATE.

Hope it is the solution you are looking for.

Good Luck & Regards.

Harsh Dave