topic Re: Code page conversion problem in Application Development and Automation Discussions

Code page conversion problem

Former Member — Wed, 30 Jul 2008 03:57:57 GMT

I am reading the file from application server using open dataset But when it comes to particular line it is gives me short dump.The short dump info says Not able to convert code page '4110' to '4102'

Wht is possible remedy for the issue.

Edited by: anil raina on Jul 30, 2008 5:59 AM

Re: Code page conversion problem

Former Member — Wed, 30 Jul 2008 04:02:49 GMT

Hi Anil,

When you are using OPEN Dataset , trying to write the content all the content should be character format.

if the there is any data like quantity and currency try to convert them into char format or else you will get the dump.

use character format only.

Re: Code page conversion problem

Former Member — Wed, 30 Jul 2008 04:43:00 GMT

But i am reading data from the application server and how can i convert data in that case.I

think if we were writing the data then we can take care of that thing...............only

Re: Code page conversion problem

Former Member — Wed, 30 Jul 2008 20:05:58 GMT

Remove the unicode flag in the program attributes and try again. This might help.

Else read as 'open dataset p_file for output in text mode encoding default / UTF-8'.

Thanks,

Mahesh

Re: Code page conversion problem

Former Member — Wed, 30 Jul 2008 21:30:19 GMT

Anil,

We were also getting a similar dump while using statement

"OPEN DATASET P_FILE FOR INPUT IN LEGACY TEXT MODE CODE PAGE '4110'.

But when replaced with "OPEN DATASET P_FILE FOR INPUT IN TEXT MODE ENCODING NON-UNICODE",

it worked fine.

Regards,

Kiran