topic Re: Breakpoints in Ecc 6.0 in Application Development and Automation Discussions

Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 09:07:40 GMT

Hi all,

I am using ecc 6.0 & i am trying to place a breakpoint on a smartform driver program but it is not allowing me to do that.

The error which i am getting is 'You cannot set more than 30 breakpoints' ..

I have checked the program is active & not a single breakpoint is placed in the program .

Please help me in this.

Regards,

Bhumika

Re: Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 09:10:20 GMT

goto the main program

Utilities~~>Breakpoints~~>Display ..

If U find any delete them ..

Re: Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 09:17:07 GMT

hi sriniwas,

It says 'Breakpoint table is empty' but it is still not allowing me to set a breakpoint.

Re: Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 09:18:57 GMT

hi ,

just start debugging ....of program ...it will show all the break points......jst delete them ..and save the program .....it will work ....otherwise set break point by writing ....break "user name" , where you want to set break point .

Regards.

Priyank dixit

Re: Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 10:04:07 GMT

hi priyanka,

actually i dont have a single breakpoint ion my program & it is still not allowing me to set a breakpoint...

Re: Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 10:07:47 GMT

Hi Bhumi

Do one thing just close this log on session and again login and open your smartform and activate it .

May be it solves your problem .

Regards

Hitesh

Re: Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 10:39:34 GMT

Hi Bhumika,

Is selection screen is available for your driver program after given selecvtion screen values put '/h ' on command promt it will go into debug mode.

then you cancheck your error.

Re: Breakpoints in Ecc 6.0

Former Member — Fri, 25 Jul 2008 11:56:10 GMT

thanks all