topic Re: Set cursor in Application Development and Automation Discussions

Set cursor

Former Member — Fri, 25 Jul 2008 08:22:51 GMT

Hi Experts ,

When I press ' ENTER ' button in Subscreen the cursor is going to Main Screen .... Could you please tell me any way to avoid this n make sure that the cursor stays in the Subscreen itself .. Its a bit urgent ....

\[removed by moderator\]

Thanks in advance

Bhaskar

Edited by: Jan Stallkamp on Jul 25, 2008 11:03 AM

Re: Set cursor

Former Member — Fri, 25 Jul 2008 08:25:48 GMT

In the Main screen PAI module

MODULE USER_COMMAND..

CASE OK_CODE.

*WHEN  'ENTER' .
 
*WHEN OTHERS.
    
ENDCASE.


ENDMODULE.

May be you are doing the mistake in that. can you show that module code.

Re: Set cursor

bpawanchand — Fri, 25 Jul 2008 08:26:19 GMT

regards

Pavan

Re: Set cursor

Former Member — Fri, 25 Jul 2008 08:30:53 GMT

hiii

when you press 'ENTER' that time use ABAP statement SET CURSOR field...it will set cursor on that field only...for more info just write SET CURSOR in your program and place cursor then and press F1..so you will get that statement for DYNPRO program too.

regards

twinkal

Re: Set cursor

Former Member — Fri, 25 Jul 2008 08:33:11 GMT

Hi Bhaskar,

If u want to show that screen again after pressing enter then u write

CALL SUBSCREEN <area>. in the PBO of the same subscreen.

i hope this will help u...

Thanks & Regards

Ashu Singh

Re: Set cursor

Former Member — Fri, 25 Jul 2008 08:41:18 GMT

Hi Bhaskar.

I would like to suggest a few references,

[SDN - Reference for Issue in Cursor position in a sub-screen|;

[SDN - Reference for cursor position for table control in case of subscreen|;

Hope that's usefull.

Good Luck & Regards.

Harsh Dave