Question Re: Ruleset selection in access request in Additional Q&A

Ruleset selection in access request

Former Member — Thu, 22 Jan 2015 18:35:12 GMT

Hello,

Is it possible for an approver to manually select ruleset for risk analysis is access request. Parameter 1025 is configured to include multiple rulesets. In access request risk analysis field is greyed out and approver is unable to select desired ruleset.

Thanks in advance.

Re: Ruleset selection in access request

alessandr0 — Fri, 23 Jan 2015 09:36:39 GMT

Dear Archana,

can you try to active the following option. Goto MSMP configuration(GRFNMW_CONFIGURE_WD) and edit the path the request is following to the stage of the owners/approvers. Select the stage and click "Modify Task Settings". Please mark the checkbox "Change Request Det" so that the request is editable for this stage.

Let us know if it works.

Regards,

Alessandro

Re: Ruleset selection in access request

madhusap — Fri, 23 Jan 2015 12:35:51 GMT

Hi Archana,

You can check if risk analysis ruleset selection field is made read only in Access request approval screen by enabling in Admin mode

1. Go to SE80

2. Select Package GRAC_ACCESS_REQUEST

3. Go to Webdynpro folder and Select Webdynpro application GRAC_OIF_REQUEST_APPROVAL

4. Double click on the Webdynpro application GRAC_OIF_REQUEST_APPROVAL and on the menu bar select Webdynpro Application -> Test -> In browser admin mode

5. Once the browser opens it shows you "The assert condition failed" error

6. Now add this &OBJECT_ID=ACCREQ/<REQID> to your browser URL. REQID can be any request ID and you can get this from your GRACREQ table.

7. Once you updated the URL as mentioned above your access request approval screen opens up. Now you go to request details section and select "Risk Violations" Tab. Right click on Ruleset field and click on Settings for current configuration as shown below

8. It opens below screen where you can make changes according to your requirement and then SAVE changes to transport request.

Regards,

Madhu.

Re: Ruleset selection in access request

Former Member — Fri, 23 Jan 2015 15:53:35 GMT

Hi Alessandro,

Thank you so much. It is working now. Changing the task settings did the trick.

Regards

Archana

Re: Ruleset selection in access request

Former Member — Fri, 23 Jan 2015 16:13:53 GMT

Hi Madhu,

Thanks for your input. I updated settings at both Web Dynpro application and task settings in MSMP workflow to make it work.

Thanks

Archana